Features; Assembly - Hart HTBG01 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Wheel Diameter ................................................................ 6 in.
Wheel Thickness ........................................................... 3/4 in.
Arbor Hole ..................................................................... 1/2 in.

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Loose Parts
List are included.
WARNING:
Do not use this product if any parts on the Loose Parts
list are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-776-5191 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
No Load Speed ............................................ 3,500/min (RPM)
Input ....................................................... 120 V~, 2.1 A, 60 Hz
WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn't hit
the grinding wheel.
TOOLS NEEDED
See Figure 2, page 11.
The following tools (not included or drawn to scale) are
needed for assembly:
 Adjustable Wrench
 Phillips Screwdriver
LOOSE PARTS LIST
See Figure 3, page 11.
The following items are included with the tool:
 Screw . ........................................................................... 4
 Washer . ......................................................................... 4
 Lock washer ................................................................. 4
 Spark shield . ................................................................. 1
 Carriage bolt ................................................................. 2
 Work rest knob ............................................................. 2
 Left work rest . ............................................................... 1
 Right work rest ............................................................. 1
 Spark shield with magnifier .......................................... 1
 Spark Deflector with LED ............................................. 2
 Spacer .......................................................................... 1
 Batteries (AAA) . ............................................................. 4
ATTACHING SPARK SHIELD TO SPARK
DEFLECTOR WITH LED
See Figure 4, page 12.
 Hold the bolt and rotate the spark shield knob
counterclockwise to loosen.
 Remove the bolt and spark shield knob.
 Place spark shield onto spark deflector with LED
assembly. Align the holes in the spark shield with the
holes in the spark deflector with LED assembly.
7 – English