Jumper Settings - Sapphire PC-AM2RD790 Manual De Instrucciones

E
English
Chapter 2 - Hardware Installation

Jumper Settings

Clear CMOS Data
Clearing CMOS Data using JP2
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
c) The overclocked settings in the BIOS resulted to the system's in-
stability or caused system boot up problems.
you can reconfigure the system with the default values stored in the
ROM BIOS.
To load the default values stored in the ROM BIOS, please follow
the steps below.
1. Power-off the system and unplug the power cord.
2. Set JP2 pins 2 and 3 to On. Wait for a few seconds and set JP2
back to its default setting, pins 1 and 2 On.
3. Now plug the power cord and power-on the system.
10
1 2 3
JP2
1-2 On: Normal
(default) Clear CMOS Data
1 2 3
2-3 On: