Charging Battery; Basic Operations - Adam Equipment IHS Serie Manual De Instrucciones

EN
3.3

CHARGING BATTERY

• Plug the power supply into the mains power, then into the back of the
IHS scale.
• The red indicator lamp will illuminate to indicate that the battery
charger is functioning properly.
• The green indicator lamp will illuminate to indicate that the battery
fully charged.

3.4 BASIC OPERATIONS

Power on and off- Press [On/Off] key to turn on the scale . Then the display on
the scale will show [88888]. Press again to turn off the scale.
Zero the scale-Depress the [Zero] to re-zero the reading.
Change division- you can use the [Change/lb/kg] key to change division.
Lb/kg- you use this to select either lb or kg weighing units
Hold -when required, such as when the reading is not stable or you cannot pause
to record a reading, you can use the [Hold] key to lock the reading, so that you
can read it easily later, after you finish reading, press [Hold] again to return to
normal weighing mode.
Note: The [Hold] key has no affect if the Hold parameter has been disabled. See
section 5.1
© Adam Equipment Company 2013 9 700660189RevD1-Jul13