Calibration - Adam Equipment IHS Serie Manual De Instrucciones

EN

4.0 CALIBRATION

• Hold [Zero] when the scale is powered on.
• The display on the scale will show "SPAN". Make sure the hook is
empty or has the slings or chains to be used in place. See Below.
• Depress the [Zero] button, the display on the scale will show "Set" then
"0" and then "0000.0" after few seconds. Zero calibration is now
complete.
• Enter the weight to calibrate with by using [Hold] key to increment a
digit then the [Change/lb/kg] key to move it across the screen left.
• For example, the display on the IHS will display "3000.0" for a 3 ton
calibration mass.
• Add the calibrated mass on the hook, it the best that the mass is close
to the capacity where possible.
• When the scale is stable, press the [Zero]. The display shows 'HOLd'.
• After a few seconds, the calibration is complete.
** To calibrate in pounds (lb) make sure that the scale is lb mode before
commencing, to calibrate in kilograms (kg) make sure the scale is in kg mode before
commencing.
When using slings, chains or other material to support the calibration mass, these
items should be hung from the scale before setting the zero point so that when the
calibration mass is added, only the weight of the calibration mass is measured by
the scale.
If an error is detected when calibrating an error message will be shown.
Err 3 is when wrong data is entered for the mass, i.e. too small or wrong division.
Err-5 means the calibration has failed.
© Adam Equipment Company 2013 11 700660189RevD1-Jul13