Original Configuration - AEB Galileo AEB170TC Manual Instrucciones De Montaje

Original configuration

The "GALILEO" is supplied configured according to the parameters given in the chart below. Considering that not
all vehicles have the same characteristics, it is necessary to make sure each time that the parameters are correct.
If, after the modification of the various parameters, the [ERASING MEMORY] function is used by means of the
laptop COMPUTER or the HAND-HELD TESTER, the parameters are automatically returned to the original configuration.
Ignition type or number of cylinders
Type of RPM signal
Type of Petrol to Alt. fuel switch-over
Fuel switch-over temperature
PLEASE NOTE: if the temperature sensor is not connected to the "GALILEO", this function has no
effect on the fuel switchover.
Petrol-Alt. fuel switch-over RPM
Duration of fuel overlap
Type of Alt. fuel level indicator
TPS type
O2 sensor type
O2 sensor reading delay
Type of O2 simulation
Option defalut lock
Maximum actuator position
Manimum actuator position
Full throttle option
Cut-Off option
Option Economical Driving
Idle TPS hysteresis
Erase memory
Is170TC-0 Rev. 211004-0
WARNING!
VEHICLE CONFIGURATION MENU
DUAL COIL
STANDARD
DECELERATION
25 °C
2000 RPM
0,4 seconds
A.E.B.
LINEAR 0-5 V
0-1 V
5 seconds
SQUARE WAVE
DISENGAGED
240 steps
20 steps
DISENGAGED
DISENGAGED
DISENGAGED
0,14 V
English
15 - 56