AEB Galileo AEB170TC Manual Instrucciones De Montaje página 18

Component description
SETTING TYPE
Type of Petrol to Alt. fuel switch-over
Fuel switch-over temperature
SWITCH
Petrol-Alt. fuel switch-over RPM
Duration of fuel overlap
The TEMPERATURE SENSOR is an OPTIONAL device; if the "GALILEO" E.C.U. ORANGE
wire isn't connected to this sensor, this function has no effect on the
PETROL-GAS change.
To have the GAS level indication (C.N.G. or L.P.G.) it is necessary that the GREEN and
WHITE wires of the "GALILEO" are connected to a special sensor.
To adapt the "GALILEO" to the different types of sensors, it is necessary to select the
correct option by means of the laptop COMPUTER or the HAND-HELD TESTER.
FUEL LEVEL
SENSOR INPUT
GREEN AND
SETTING TYPE
WHITE WIRE
Type of Alt. fuel level indicator
The Throttle Position Sensor is mechanically connected to the butterfly of the gas pedal.
It sends a variable voltage signal to the E.C.U. that is proportional to the opening angle of
the butterfly. In the latest generation of vehicles where the opening of the butterfly is
achieved through an electromechanical device as opposed to linkage, the T.P.S. signal can
be taken at the sensor, which reads the position of the gas pedal.
T.P.S.
THROTTLE
SETTING TYPE
POSITION
SENSOR
TPS type
BLUE-YELLOW
WIRE
Idle TPS hysteresis
If, after the modification of the various parameters, the [ERISING MEMORY] function is
used by means of the laptop COMPUTER or the HAND-HELD TESTER, the parameters are
automatically returned to the original configuration.
ERISING
MEMORY
SETTING TYPE
Erising memory
18 - 56
VEHICLE CONFIGURATION MENU
ACTIVE SETTING
Deceleration
Acceleration
Gas Starting
0-40 °C
1000-3000 RPM
0-1 seconds
WARNING!
VEHICLE CONFIGURATION MENU
ACTIVE SETTING
A.E.B.
0-90 Ohm
Reserve Indication
VEHICLE CONFIGURATION MENU
ACTIVE SETTING
Linear 0-5 V
Linear 5-0 V
Direct switch
Inverted switch
Monobosch
No TPS
0-0,5 V
VEHICLE CONFIGURATION MENU
ACTIVE SETTING
"ENTER" erising
"ESC" exit
Is170TC-0 Rev. 211004-0
English