Star Progetti HELIOS TOWER Instrucciones De Uso página 8

15.Pay particular attention when used in unmanned environments.
16.Periodically inspect the completeness of the appliance by eye. In the event of any imperfection do not use it and
immediately contact the manufacturer or an authorized Technical Assistance Centre.
17.Before cleaning or doing any maintenance turn the product off and disconnect it from the electricity network by
switching the plant off.
18.If the product falls or receives a hard knock get it checked by the manufacturer or an authorized Technical Assistance
Centre.
19.During maintenance do not touch the bulbs directly but handle only by the end caps. The bulb can be damaged by
contact with bare hands; in this case the covering warranty is no longer valid.
20. Should you accidently touch the surface of the bulb, clean it immediately with a soft cloth moistened with alcohol.
21.In the event of malfunction and/or breakdown turn the appliance off and immediately contact the manufacturer or an
Authorized Technical Assistance Centre.
22.Original Star Progetti spare parts must be used in any repairs. In the event of damage to the lead or its plug
immediately replace it, this should be carried out at the premises of the manufacturer or an authorized Technical
Assistance Centre. Use alead with similar characteristics.
23. Switch the main plant supply off when:
a) there is a malfunction;
b) you decide to clean the outside;
c) you decide not to use the appliance for a long period of time.
24.Do not cover or obstruct the front grille when in use.
25. Use a multi-polar switch with minimum contact gaps of 3 mm when installing the appliance.
26. Do not cover or obstruct the appliance whilst it is on.
27. Keep the front grille clean.
28.If you decide to permanently remove the appliance, switch it off and disconnect it from the mains, and then keep it
well out of the reach of children and the handicapped. It is also recommended to make it unusable by cutting its supply
cable off.
29.Do not use the appliance in conjunction with programmers, timers or other tools capable of turning it on
automatically.
30.Heaters must be switched on and switched off one by one. Do not use the main switchboard for switching on or
switching off the units, to avoid voltage surges which could burn out the bulb.
8