Honda HHB25 Manual Del Propietário página 61

1. Set the hot air duct on the engine top cover by aligning the groove
and locking tabs with the ribs of the engine cover as shown.
2. Tighten the 3.5 x 8 mm self-tapping screw securely.
There are no screw holes to mount the hot air tube kit. Drive the
self-tapping screw into the cover and tighten it.
RIB
3. Remove the air cleaner cover (see page 24).
4. Install the hot air joint to the air cleaner case as shown.
Check that the locking tabs of the hot air joint lock against the ribs of
the air cleaner case securely.
AIR CLEANER CASE
58
SECOND HOLE
FROM LEFT END
LOCKING TABS
ENGINE COVER
GROOVE
HOT AIR DUCT
3.5 x 8 mm
SALF-TAPPING SCREW
FIRST HOLE
FROM RIGHT END
HOT AIR JOINT
LOCKING TABS