Nozzle Change Operation; Reduced Gas Flow Rate Setting For Hob Taps - Proxy COC54EB-WP Guia Del Usuario

NOZZLE CHANGE OPERATION

1. Please use driver with special
head for removed and install nozzle as. (Figure 13)
2. Please remove nozzle (Figure 14)
from burner with special nozzle driver
and install new nozzle. (Figure 15)
Figure 13
Figure 14

REDUCED GAS FLOW RATE SETTING FOR HOB TAPS

Figure 16
Figure 17
To adjust your oven acc. to the gas type, make the adjustment for reduced
flame carefully by turning with a small screwdriver as shown below on the screw
in the middle of the gas cocks as well as nozzle changes (Figure 16 and 17).
GB
Figure 15
1. Ignite the burner that is to be adjustment and
turn the knob to the reduced position.
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to adjust
the flow rate adjustment screw. For LPG (Butane-Pro
pane) turn the screw clockwise. For the naturel gas,
you should turn the screw counter- clockwise once.
"The normal length of a straight flame in the
reduced position should be 6-7 mm."
4. If the flame is higher then the desired
position, turn the screw clockwise. If it is smaller
turn anticolockwise.
5. For the last control, bring the burner both
to higt-flame and reduced positions and check
whether the flame is on or off.
Depending on the type of gas tap used in your
appliance the adjustment screw position may vary.
20