Step By Step Operation - JF 30P Manual Técnico De Operación

5.3- Step by step operation

5
1
a) Check if there is not foreign objects in the feeding chute.
b) Check if is necessary lubricate the bearing of the impeller or doing knifes maintenance.
c) Adjust the chute (1) according described on previous page.
d) Start the motor. If you have a combustion engine, observe the manufacturer instructions.
e) IMPORTANT: Put the product on feeding nozzle (5) continuously and in quantity
compatible with the machine and feeding nozzle capacity.
NOTE: To assure the feeding homogeneity, insert each new bunch on the end of previous
bunch.
Then you can have the maximum performance, quality and homogeneity of the spricket
material.
16