Maintenance And Cleaning - X-LITE X-803 Manual De Instrucciones

4

MAINTENANCE AND CLEANING

- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the visor with dry and warm air without wiping it.
- To keep the features of the visor in good conditions over time, let the helmet dry
in a ventilated and dry place with the visor open after use. Keep it away from heat
sources and store it in a place away from direct light.
- Do not use solvents or chemical products.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- a liner
- pads of the side cheek pads (right and left)
- strap covering
All components can be completely removed and washed. The cheek pads are also
characterised by removable inner expanding foam padding.
1 CHEEK PAD DISASSEMBLY
1.1 Unfasten the chin strap (see relevant instructions).
1.2 Gently pull the red strap in the front area of the pad of the left cheek pad to release
the safety lever on its back (Fig.11).
1.3 Hold the front part of the pad of the left cheek pad and turn it upwards to unhook
the front and upper hooks on its back (Fig.12).
1.4 Pull the back of the pad of the left cheek pad towards the inside of the helmet to
undo the snap fastener on its back (Fig.13).
1.5 Pull the front part of the left cheek pad base upwards until the front fastening "A"
of the frame releases from its corresponding plate between the outer shell and the
polystyrene cheek pad (Fig.14).
1.6 Completely remove the helmet left cheek pad, by flapping the pad base frame out
of the cavity between the outer shell and the polystyrene cheek pad. Then, pull the
rear guide of the pad base frame out of its corresponding plate between the outer
shell and the polystyrene inner shell.
1.7 Repeat these steps with the right cheek pad padding.
Do not remove the polystyrene cheek pads from the helmet shell.
2 DISASSEMBLY OF THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To make it easier to wash the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from the
fabric lining. To remove the padding, proceed as follows after removing the cheek pads
from the helmet (see instructions above).
2.1 Gently remove the inner expanding foam padding from the fabric lining of the left
cheek pad (Fig.15).
inner visor from the visor. Using a damp and soft cloth,
®
INSTRUCTIONS FOR USE
X803
19