Ventilation System - X-LITE X-803 Manual De Instrucciones

- Use the Nolan Emergency Release System (NERS) for providing aid only if you
have proven expertise and qualifications in the field. If in doubt, call the appropri-
ate emergency personnel.
WIND PROTECTOR AND BREATH DEFLECTOR
(Available as standard or accessory/spare part).
Under certain conditions of use, helmet performance can be improved by using these
accessories.
The Wind Protector reduces unpleasant infiltrations of air under the chin. It is hooked to
the inner chin guard by means of two snap buttons on its back.
See Fig.25 for assembly and disassembly operations.
The Breath Deflector prevents the formation of condensation on the visor by deflecting
the air flow downwards. It is hooked by means of three elastic plates inserted between
the front air diffuser and the visor sealing edge.
See Fig.26 for assembly and disassembly operations.
The wind protector and breath deflector accessories can be easily removed.
Correct assembly of these accessories can be checked by pulling them gently
towards the inside of the helmet with thumb and forefinger. If they move, repeat
assembly operations.

VENTILATION SYSTEM

The ventilation system of the helmet consists of:
Lower Ventilation System
- It allows ventilation in the mouth area and conveys the air directly on the visor
reducing fogging. See Fig.27 for opening and closing operations.
- It allows ventilation in line with the mouth (Fig.28).
Front Ventilation
It allows direct ventilation in the front area of the head, even at low speed.
See Fig.29 for opening and closing operations.
Top Ventilation System
It allows direct ventilation in the top area of the head, even at low speed.
See Fig.30 for opening and closing operations.
Side Ventilation
It allows continuous air recirculation in the mouth and visor area (Fig.31).
Rear Ventilation System
It allows warm and stale air to flow out ensuring an optimum comfort inside the helmet
(Fig.32 – Fig.33).
INSTRUCTIONS FOR USE
X803
23