Serial Device Server
Despite there are 4 different possible host only one can communicate through the device at the same time. The reason
to provide room for 4 different host IP's is related to provide a host backup service, in case the main host ma fail for
some reason.
Finally, you can choose between use a lightweight UDP protocol or connection oriented TCP. Later you will must select the
same Ethernet protocol on TG-HONEYWELL device (communications setup). Note that encrypted communications scheme
can only be used under TCP.
4.4 Access setup
The Web interface password can be modified on this window. Just type the new password both on 'Password' and 'Repeat
password' text boxes. The password update will be done after the save button be pressed (button located on the page top
bar).
User name
Password
Repeat password
4.5 About the TP-IP1 SEC
The Firmware and Bootloader version and the M.A.C. address of the Network device can be checked on this window.
Changes Control
Revision
0
1
Honeywell Life Safety Iberia
C/Pau Vila, 15-19,
08911 Badalona (Barcelona)
España
Tel. 902 03 05 45
infohlsiberia@honeywell.com
www.honeywelllifesafety.es
TG-IP1-SEC
Sets the new user name. Capital and lower case letters must be considered. The minimum length is 4 characters.
Sets the new password. Capital and lower case letters must be considered. The minimum length is 4 characters.
To be able to change the access password it is necessary to repeat password.
Details
First version edit.
Figures update.
Access setup
Edits
ALD
OSLL
HLSI_MA-DT-1412_01
October 2017
© 2017 Honeywell International Inc.
Date
20/04/2017
17/08/2017