CLEANING EXTERIOR AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. To clean exterior, or to reduce static elec-
tricity and dust build-up, wipe outer surface
of vacuum cleaner and attachments. Use a
clean, soft cloth that has been dipped in a
solution of mild liquid detergent and water,
then wrung dry. Wipe dry after cleaning.
TO CLEAN DIRT SENSOR OPTICS
The dirt sensor optics consist of two optic
cells located inside the dust bag port.
Occasionally, it may become necessary
to clean the two optic cells to ensure
maximum performance.
Dirt Sensor
Optic Cells
DUST BAG REMOVAL AND REPLACEMENT
WARNING
Always unplug power cord from electrical
outlet before performing maintenance to
the vacuum cleaner.
DUST BAG STYLE O
TO REMOVE DUST BAG
1. Pull on the
dust bag
cover latch
Dust Bag
located on
Cover Latch
the side of
the dust bag
cover.
NOTE: Do
not pull on
the Dust bag.
CLEANING DIRT SENSOR OPTICS
Wash attachments in warm soapy water,
rinse and air dry. Do not clean in
dishwasher.
CAUTION
Do not use attachments if they are wet.
Attachments used in dirty areas, such
as under a refrigerator, should not be
used on other surfaces until they are
washed. They could leave marks.
It is recommended the optic cells be
cleaned:
• When the red light stays on
continuously.
• When dirt or dust adheres to the
optic cells.
• Whenever the dust bag is removed.
To clean the sensor, wipe the optic cells
with a soft, dry cloth. Never use
cleaners or liquids as they can help
speed the recoating of the optic cells
and make it necessary to clean them
much sooner than normal. The dirt sensor
area can be reached by removing the
dust bag.
Bag
Safety Stop
Bag Collar
Dust Bag
Dust Bag
Holder
Dust Bag
Chamber
Motor
Safety
Filter
- 18 -
2. Grasp the
dust bag collar
and pull gently,
carefully
removing the
dust bag from
the dust bag
holder.
3. Dispose the
used dust bag.
Do not reuse
dust bag.
NOTE: Check
the dust bag
holder and the
motor safety
filter for dirt
or clogs.