Inverter Features; Before Using Your Power Inverter - Schumacher PI-140 Manual Del Usuario

1.13 Do not modify the AC receptacle in any way.
1.14 Do not try extending or otherwise changing the 12 volt power cord supplied with your
inverter. Make sure the cord connections are tight.
1.15 Incorrect operation of your inverter may result in damage and personal injury.
1.16 Do not use the inverter with a product that draws a higher wattage than the inverter
can provide, as this may cause damage to the inverter and product.
1.17 Do not open – No user serviceable parts inside.
1.18 This device does not include an internal Ground Fault Circuit Interrupter (GFCI).
1.19 Restrictions on Use: This inverter may not be used in life support devices or
systems. Failure of this inverter can reasonably be expected to cause failure of
that life support device or system, or to affect the safety or effectiveness of that
device or system.

2. INVERTER FEATURES

1. LED Indicator Light (Green = Power ON)
2. Standard Electrical 120V AC Outlet
3. 12 Volt Power Plug
4. USB Power Port
5. Low-Battery Protection

3. BEFORE USING YOUR POWER INVERTER

NOTE: This inverter is designed to be used with a single battery, up to group 31
type (130 Ah or smaller in size).
NOTE: Do not use the inverter with a product that draws a higher wattage than the
inverter can provide, as this may cause damage to the inverter and product.
When you turn on a device or a tool that runs on a motor, the device basically
goes through two stages:
1. Start Up – Requiring an initial surge of power (commonly known as the
"starting" or "peak" load).
2. Continuous Operation – Power consumption drops (commonly known as the
"continuous load").
The wattage (WATTS) or amperes (AMPS) can normally be found stamped or
printed on most devices and equipment, or in the user's manual. Otherwise,
contact the manufacturer to find out whether the device you want to use is
compatible with a modified sine wave.
• 5 •