Care And Cleaning; Cleaning The Lint Filter; Cleaning The Outside Of The Machine - grandimpianti GD6 Instrucciones De Funcionamiento

www.groupdynamics-laundry.com
sales@groupdynamics.lv

Care and cleaning

Cleaning the lint filter

If the display reads "Insert filter" the tumble dryer
will not start. Insert the lint filter in its holder.
The lint filter must be cleaned after each load. If
you have very hard water, this can cause
limescale deposits in the lint filter. Check for any
limescale deposits when cleaning the lint filter
and, if necessary, wash the filter by hand.
1. Grasp the filter handle and pull it towards you.
2. Pull the filter out of its holder.
3. Open the filter and remove the lint from all
sides of it by hand. Use a soft, dry cloth to
remove any deposits.
4. Replace the filter in its holder.
Note!
If you have hard water, the filter should be
washed with water to get rid of any limescale
deposits. Use a sponge and a little dishwashing
detergent if necessary. Dry the filter carefully
with a towel. If you cannot remove the limescale,
you can buy a new filter from the retailer where
you bought the tumble dryer.
14

Cleaning the outside of the machine

Clean the outside of the machine and the
programme panel with a mild cleaner. Do not use
solvents, as these can damage the machine. Do
not hose down or spray the machine with water.
Note!
Do not allow dust to accumulate around the
machine. Keep the area around the tumble dryer
clean and cool; dust, heat and moisture prolong
drying times.