Assembly - inventiv INV T6553 TBV Manual De Instrucciones

6. ASSEMBLY

WARNING! Unpacking and completing the assembly should be done on a flat and
stable surface, with enough space for moving the machine and its packaging, always
making use of suitable equipment. Disposal of the packaging should be done in
accordance with the local regulations in force.
6.1 ASSEMBLING THE GRASS CATCHER
6.2 ASSEMBLING THE HANDLE
• Type I
Return the lower part of the handle (1) to the work position and fasten it to the side chassis
supports as shown in the diagram, using the handles (2) and relative nuts and bolts.
Make sure the pins (2a) are inserted in one of the two holes (2b) on the side supports of the
6
EN
With the grass catcher
turned upside down,
snap on all the plastic
sections (21) to the
chassis (22), using a
screwdriver as illus-
trated.
chassis so as to achieve the
correct height of the handle.
Assemble the top part (3)
and fasten in place using the
levers (4) and relative screws
previously removed from their
respective holes.
The rings (9) on the levers (2)
and (4) must be screwed on so
that the distance from the han-
dle is around 9 mm (when the
levers are released) to ensure
secure fastening without requir-
ing too much effort to tighten or
release the levers.
Secure the control cables using
the cable fastener (5)..
• Manual ignition models
Insert the starter cable (6) in
the spiral (7) and tighten the
nut (8).
• Manual ignition models
Insert the supplied battery in
the relative engine compart-
ment (par. 8.2) .