IMPORTANT The adjustment must be made
when the engine is off.
9.3 BATTERY RECHARGING (where applicable)
• Electric push-button ignition models:
Read the engine instruction manual for instruc-
tions regarding autonomy, recharging, reinstating
and maintenance of the battery.
9.4 CLEANING THE INTERIOR
To clean the internal parts of the lawnmower:
– connect a water hose to its pipe fitting (1);
– lower the cutting height as far as possible;
– always stand behind the lawnmower handle;
– start the engine.
9.5 WINTER MAINTENANCE
– Carefully clean all external parts of the machine and engine.
– Lubricate all rotating parts.
– Drain the engine of fuel to prevent petrol deposits in the carburettor.
– Drain the engine of oil and top it up.
– Unscrew the sparking plug and pour 3 cm3 of engine oil through the plughole. Turn the
engine over for two or three revs using the starting cable to distribute the oil, then refit the
plug.
– Check or change the starting plug.
– Clean the air filter with a compressor or replace it if it is too dirty.
– Lubricate the transmission and control cables and levers.
– For best cutting, clean the cutting plate and sharpen and balance the cutting means.
At the end of the season, before putting your lawnmower away for use in
the next fine season, we advise you to check some points.
This task can be entrusted to the Mr. Bricolage after-sales service.
13 EN