MELICONI HP600 PRO Instrucciones De Uso página 13

Headphones (Image 1)
Headphone details:
A. Recharge contact points
B. Headphones on/off light (RED)
C. On/off button
D. Volume control
E. AUX port
F. Micro-USB port
Base (Image 2)
Details of base unit:
H. charging clips
I. LED light (* refer to the table "Meaning of LED light colours"):
L. channel selection switch
M. Toslink optical digital audio input
N. stereo audio input for 3.5 mm jack cable
P. coaxial digital audio input
Q. input for connecting the AC adapter
• Connect the AC adapter cable to the connector "Q" (PWR) on the back of the charging dock.
• Connect the AC adapter to the power outlet.
• Place the headphones on the charging dock in order to recharge the batteries. The initial charge will take at least
4-5 hours
N.B. Before making any connections, ensure that the devices are switched off
• Remove the headphones from the charging dock.
• Depending on the type of audio output available on your device, connect the charging dock to the device using the
appropriate cable. In the case of a TV, make sure a specific setting of the TV set is not required to activate the audio
output you are intending to use. For the specific setting procedure, refer to the instruction manual of the TV.
• Turn on the charging dock and the audio source (e.g. the TV).
• Whilst remaining close to the charging dock, switch on the headphones by pressing button "C" for a few seconds,
until LED light B turns red.
• Put the headphones on and use button "D" to adjust the volume and obtain proper sound reproduction.
• If the headphones fail to reproduce the sound, or if there is audio interference, briefly press button "C". If the problem
persists, please consult the "TROUBLESHOOTING" section.
Headphones positioned correctly on the
Blue LED
base and battery fully charged
Red LED Audio signal input on the base
For normal use, simply turn the headphones on and off, exclusively by pushing button "C" positioned on the headphones.
When the headphones are not in use, turn them off to avoid draining the battery, and store on the charging dock so
that they will be fully charged for subsequent use. In the absence of an incoming audio signal, the charging dock does
not switch off immediately, but after 4 minutes (the RED indicator light "I" goes out). If the headphones are not being
used for a long period of time, it is advisable to disconnect the AC power adapter of the charging dock from the mains.
Installation
Battery charging
Audio source connection
Meaning of LED light colours
Lit
Headphones positioned correctly on the
base and battery charging
X
Use
Flashing
Headphones not positioned correctly
on the base
Audio signal not identified
Off
11