Installation; Start-Up; Programming Of The System - Huwil Huwilift E-Verso Manual De Instrucciones

Notice for furniture manufacturers:
This electromechanical fitting is subject to testing according to the machinery
directive 2006/42/EC, which requires an evidence of conformity for the operable
piece of furniture from the furniture manufacturer, resp. distributor.
On the part of the furniture manufacturer all norms and legal specifications for the
operation of this electromechanical fitting have to be obeyed.
The asembly instruction as well as the operating manual have to be handed over
to the final customer.
The compliance with this safety notice will guarantee long-lasting satisfaction with
your Huwilift E-Strato /-Verso / -Senso.
Please refer to us for any doubt or question you might have.
3.

Installation

In the factory settings of the manufacturer the control devices can be installed
without any allocation or matching to the remote controls. The wiring to the drive
units as well as to the power supply has to be effected according to the assembly
instructions.
4.

Start-up

Before starting up, please check that there are batteries in the remote control/s.
If not, please proceed according to point 14.
5.

Programming of the system

In the factory settings the remote controls (senders) are not programmed, the
system must therefore be programmed first. Every remote control contains one of
4.1 million possible unicum numbers.
The control unit only accepts commands of known remote controls. Every receiver
contains a list in which it can enter up to 5 remote control numbers.
In the learning mode, single remote controls can be added to or removed from
this list.
If more than 5 remote controls are stored, the oldest entries are overwritten.
26
© HUWIL 02/2009 Huwilift E-Verso / E-Strato / E-Senso/ E-Senso+