Installing Remote Controls (Senders) - Huwil Huwilift E-Verso Manual De Instrucciones

6.

Installing remote controls (senders)

To install a remote control in the control unit, please proceed as follows:
6.1 Make sure that the device is properly installed and that it is connected to the
power supply.
6.2 Move the flap about 10 cm by hand.
This actuates the learning mode in the control unit. Within a period of 3 seconds
the remote controls can be installed.
6.3. Keep the button of the remote control pressed for at least 15 seconds.
The flap of the cabinet confirms with an open-close movement that the remote
control unit has been programmed into the memory of the control unit.
6.4 Then check that the remote control initiates a movement of the flap.
Take care that only one control unit is operating in the learning mode.
If several control units operate in the learning mode at the same time,
the remote control will be installed simultaneously in each of the control
units.
© HUWIL 02/2009 Huwilift E-Verso / E-Strato / E-Senso/ E-Senso+
3
seconds
15
seconds
27