Velleman CAMCOLVC13 Manual Del Usuario página 5

sufficiently charged before use. Charging via PC might take from 8 to 12
hours, via an adaptor charging will take ±4h.
• To set date and time, locate the program DateTime.exe on the included
CDROM and double click it. A screen pops up showing date and time;
correct when necessary and click Save, followed by OK. Disconnect the
USB cable and switch the camera on (standby mode). Switch it off again
and wait for at least 1 minute for the time update procedure to complete.
• Make sure to disconnect the device from the USB port in the appropriate
manner.
Using the camera
• To switch the camera in standby mode, shortly press the power button
[4]. The LED under the power button turns red. Wait at least 5 seconds
fro the camera to initialize.
• When no button is pressed for 3 minutes, the camera will automatically
shut off to save battery power.
• Press the live record button [5] to start recording. The power LED [4]
starts flashing. Press the live record button [5] again to stop recording.
• In standby mode, press the snapshot button [6] to take a snapshot.
• When using the camera in dark circumstances, switch on the LEDs [2] at
the front of the camera by pressing the LED button [7]. Press again to
switch the LEDs off.
• Press the LED flash button [8] to make the LEDs [2] flash. This setting
can be used e.g. as a warning signal.
Mounting the camera
• The camera comes with different mounting brackets for different
applications (see image below): bicycle mount (1), helmet mount (2),
elastic strap (3), wrist strap (4) and clip (5).
28.07.2010
CAMCOLVC13
5
©Velleman nv