GENERAL INFORMATION
GENERAL INFORMATION
RANGE
MODEL
Single-phase 1500 W electrical heating
element
Single-phase 2200 W electrical heating
element
Single-phase 3000 W electrical heating
element
Three-phase 3800 W electrical heating
element
Dear heating engineer,
we congratulate you on proposing the accessory heating ele-
ment.
While your technical skills and knowledge will certainly be more
than sufficient, this booklet contains all the information that
we have deemed necessary for the device's correct and easy in-
stallation.
Please accept our thanks and our congratulations on your choice
of product.
CONFORMITY
Low Voltage Directive 2014/35/EU
Electromagnetic Compatibility Directive 2014/30/EU
EN 61010-1/2001 standard
EN 61000-6-2 standard
EN 61000-6-4 standard
9
For warranty conditions refer to what indicated in the prod-
uct in combination with the accessory.
CONTENTS
1
2
3
4
5
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
6
Wiring diagrams . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
7
8
9
Adjustment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17
10
11
Start-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
12
Adjustment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
ENGLISH
The following symbols are used in this manual:
9
CAUTION! = Identifies actions that require caution and
adequate preparation.
0
STOP! = Identifies actions that you MUST NOT do.
1
GENERAL WARNINGS AND ESSENTIAL SAFETY
REGULATIONS
CODE
9
20131666
Upon receiving the product, be sure to verify the integrity
and the completeness of the consignment, and contact the
Agency from which the accessory was purchased if any dis-
20131667
crepancies are encountered.
9
20131669
This instruction sheet in an integral part of the booklet of
the equipment on which the accessory is installed. Please
20131670
refer to said booklet for GENERAL WARNINGS and ESSENTIAL
SAFETY REGULATIONS.
2 DESCRIPTION OF THE ACCESSORY
The accessory HEATING ELEMENT acts as an integration for an
accumulation system for producing hot water. It must be used
exclusively in conjunction with the boilers indicated in the first
table of the "Technical specifications".
This manual, Code
- Rev.
comprises
pages.
11
GENERAL INFORMATION
General information