Assembly Driven By Diesel Or Gasoline Motors; Montaje De La Centrífuga - JF 15D Manual Técnico De Operación

Assembly driven by diesel or gasoline motors

The machine and the motor are installed on a one-piece base.
JF Máquinas stand is equipped with special rubber feet which do away for the need of any
other base.
FASTENING BASE
1- This base has been designed for diesel or gasoline motors but it also can used for electric
motors.
BASIC INSTALLATION SEQUENCE
1- Install the machine and the motor on the base.
The base is already prepared with specific places for
placing the machine and supporting it, as well as
moveable rails for fastening the motor. Likewise, the
motor is placed on the moveable base.
Once the machine and the motor are placed on the
base, then it is necessary to proceed in aligning the
pulleys. Following that, install the base feet for the
machine and the motor. Then place the belts and
stretch them adequately, using the lever on the base.
16
MANUAL TÉCNICO DE OPERACIÓN - JF 15D
Montaje de la centrífuga
La centrífuga es equipamiento opcional, suministrado mediante pedido. Cuando adquirido,
viene desmontado y embalado. Para su montaje, observe las instrucciones a continuación:
ASTA
PIE DE LA
CENTRÍFUGA
TUERCA CONTRATUERCA
Enrosque una punta del asta en el pie de la centrifuga.
Pase la otra punta por el orificio existente en la boca y
coloque tuerca. Observe en la figura arriba la posición
de la tuerca y de la contratuerca.
Encaje el tubo curvado en la boca de entrada
de la centrífuga.
Encaje los tres pies en los rebajos existentes
en el cuerpo de la centrífuga.
Al acoplar la centrífuga en la
maquina, recuerde colocar el
anillo de goma (A).
15