HAIRCUT X-POWER Manual De Usuario página 17

2.3 Adjusting the cutting height (see figure 4)
Without an attachment comb, the default cutting height is 0 mm. It can be adjusted
up to 1.6 mm by pressing the adjustment lever (G).
There are six possible cutting heights: 0 mm, 0.9 mm, 1.1 mm, 1.3 mm, 1.45 mm
and 1.6 mm.
To adjust the cutting height, proceed as follows:
Turn the knurled knob (B) to the "lock" position (fig. 4a).

Press the lever (fig. 4b) to select the desired cutting height among the 6 heights

available. To free the adjustment lever (G), release the locking knob (B) (fig.
4c).
2.4 Using the attachment combs
The cutting length can be increased by using attachment combs (fig 4d).
4 attachment combs are available, giving cutting lengths of 3, 6, 9 and 12 mm.
The clippers must be switched off and unplugged from the power socket
before fitting attachment combs.
Positioning the attachment comb: Slide the attachment comb over the blades

as far as the stop.
Removing the attachment comb: grasp it by the sides and pull it backwards.

17
EN