Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
Note: If unit is equipped with a rigid or swivel spout/gooseneck, install spout/
gooseneck fi rst.
Rigid Gooseneck Installation:
1. Apply Tefl on tape, Loctite, or pipe joint compound to threads of gooseneck.
Thread gooseneck into outlet hole of body until joint is secure and
gooseneck faces desired direction.
Swing Nozzle/ Swivel Gooseneck Installation:
Note: Silicon grease is applied to the interior swivel cavity of the body prior to
shipment. No additional grease is required.
2. Remove plastic cap from body outlet.
3. Insert nozzle/gooseneck into body cavity.
4. Tighten swivel lock nut using 1 5/16" wrench.
Faucet Body Installation:
5. Flush debris from water lines then shut off water supply.
6. Drill two holes, approximately 1" to 1 1/4" diameter, in deck or sink where
faucet body is to be installed. Holes must be 4" or 8" between centers, as
applicable.
7. Remove washers and nuts from B-0425-M supply nipple kits, or similar ½"
NPT inlets, and apply Tefl on tape or thread sealant to the threads on one
end of the nipples. Thread this end into the inlet hole of the faucet fl ange
until the joints are secure.
8. Apply plumbers putty to faucet fl ange mounting surfaces and insert the
supply nipples though the holes in the deck or sink.
9. Secure faucet in place with supply nipple kit washers and nuts.
10. Connect water supplies to nipples.
Pre-Rinse Installation:
11. After installation of the faucet body per steps 5 through 10, apply Tefl on
tape, Loctite, or pipe thread compound on the bottom of the riser. Slide
fi nger hook onto riser before riser installation. Thread riser into outlet
hole of faucet body until joint is secured.
12. Install wall bracket and fi nger hook, tightening all fasteners securely.
13. Rotate spring and hose assembly until they face desired direction.
14. Turn on water supplies and check for leaks.
3
Publicidad
