Adjusting The Display; Setting The Colors; Transporting The Monitor; Cleaning The Monitor - Siemens Nixdorf MCM 1701 Instrucciones De Servicio

Loading and storing the display size and position
Storing the settings = press the right side of the button
RELOAD SAVE
Loading the default settings = press the left side of the button
After you loaded the default settings, some individual settings for your CRT
i
controller will be needed.

Adjusting the display

The mode indicator must be bright. You can switch it on or off using the COLOR
button.
Correcting distortion
Image cushion-shaped = press the right side of the button
Image barrel-shaped = press the left side of the button

Setting the colors

The mode indicator must be bright. You can switch it on or off using the COLOR
button.
Adjusting the blue portions
Increasing the blue portions = press the right side of the button
Reducing the blue portions = press the left side of the button
Adjusting the green portions
Increasing the green portions = press the right side of the button
Reducing the green portions = press the left side of the button
Adjusting the red portions
Increasing the red portions = press the right side of the button
Reducing the red portions = press the left side of the button
Loading and storing the colors
Storing the colors = press the right side of the button
RELOAD SAVE
Loading the default settings = press the left side of the button
Some standard video modes are preset by the factory. For your CRT
i
controller some individual settings will be needed.
A26361-K316-Z1-2-6419
17" color monitor
English - 7
17" color monitor

Transporting the monitor

Transport the monitor with care and only in its original packaging (to predict
!
it against knocks and jolts). Above all, never drop the monitor (risk of
implosion).

Cleaning the monitor

Always pull out the power plug before you clean the monitor.
!
Do not clean any interior parts yourself, leave this job to a service
technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic.
Ensure that no liquid will run into the system.
Ensure that the ventilation areas of the monitor are free.
Wipe the monitor housing with a dry cloth, or if particularly dirty, use a cloth which
has been moistened in mild domestic detergent and then carefully wrung out.

Error handling

The display is too small or not centered
The monitor recognizes an undefined mode.
The position and the colors of the display must be adjusted.
Color displacements
If color displacements occur on the screen, you must degauss the screen.
To do this, press the DEGAUSS button to the left of the power indicator.
!
Never press the DEGAUSS button for more than 10 seconds and wait 20
minutes at least before pressing the button again.
8 - English
A26361-K316-Z1-2-6419