Appendix - Faq - Dynex DX-E402 Manual De Instrucciones

10

Appendix - FAQ

I have Windows 98 on my computer or I cannot connect to the router.
How do I configure my computer for the router?
To install the TCP/IP component on your computers:
1 On the Windows taskbar, click Start, Settings, then click Control Panel.
2 Double-click the Network icon, then click the Configuration tab in the Network
window.
3 Click Add, click Protocol, then click Add.
4 On the Select Network Protocol page, under Manufacturers, highlight Microsoft.
5 Under Network Protocols, highlight TCP/IP, then click OK. The TCP/IP protocol takes
effect after you reboot your computer.
To configure TCP/IP to obtain an IP Address automatically on your computers:
1 Connect the local computers to the LAN ports on your router using category-5 cables
with RJ-45 connectors.
2 On the Windows taskbar, click Start, Settings, then click Control Panel.
Appendix - FAQ