Starting The Machine; Control Panel; Use Of The Self-Cleaning System; Programming And Use Of The Computer For Controlling The Self-Cleaning System Of The Central Unit - Sistem-Air Autocleaner Manual Tecnico

Autocleaner instructions manual

10 - STARTING THE MACHINE

10.1 Control panel

The AUTOCLEANER system is controlled directly bu the board display of the vacuum unit.

11 - USE OF THE SELF-CLEANING SYSTEM

When the AUTOCLEANER system is connected to the vacuum unit, it is controlled directly through the
parameters entered in the vacuum-unit display.
The frequency of the cleaning air blow is automatically set by the software.
11.1 Programming and use of the computer for controlling the self-cleaning
system of the central unit
Central vacuum units and dust separators are provided with a handy display with a membrane keypad
like in the picture below.
By means of this display and its membrane it is possible to give the computer the commands for the
vacuum unit management and make choices concerning the functioning, the programming of ordinary
maintenance and it is possible to enter personal data.
Personal data entry works as following:
• Press the up
• Press enter
• Press the Right (dx)
• Press ESC
16
and down arrows
to save data or confi rm the selection
and Left (sx)
to exit the display screen.
to scroll the display screen
arrows to change the values on the display
05/07/11 Rev:1.0.0