Emc Measurement Procedures For Lisn Hm6050 - Hameg Instruments HM6050-2 Manual De Instrucciones

according to IEC364-4-41 (CENELEC HD 384.4.41 and VDE 0100 Part
410). Due to the circuitry of the HM6050-2 a maximum leakage current
of 800 mA can occur.
It is not possible to operate the HM6050-2 at a mains outlet with
a leakage current circuit breaker.
Attention! Danger of death!
The LISN has to be grounded according to the regulations (Cenelec
HD384/DIN VDE0100) separately; otherwise conductive parts of the
housing, which may be touched by the user, lie on a dangerous
high voltage level.

EMC measurement procedures for LISN HM6050-2

Measurements have to be performed according to the VDE regulations
VDE 0877 Part 1.
After the test setup is completed according to the regulations one can
begin with the measurement procedures.
Follow these procedure steps:
1. Set HM6050-2 to operation (power on)
(Transient limiter in active status (LED off))
2. Set DUT (Equipment under test) to operation
3. Set Spectrum Analyzer/Test Receiver to operation
4. Connect HM6050-2 to the input jack of the Spectrum Analyzer/Test
Receiver via a coaxial HF cable.
Subject to change without notice
29