Mounting Steps; Panel Pc El 1800(S) / El 1850(S) - Lenze L-force Controls EL 1800 Instrucciones Para El Montaje

4.4

Mounting steps

4.4.1

Panel PC EL 1800(s) / EL 1850(s)

How to perform the installation:
1. Cut the mounting cutout into the control board (¶ 32).
2. Check that the gasket under the front panel is located correctly.
3. Place the device in the mounting cutout and secure it against
falling−down with one hand.
4. Fit all screw clamp fixings as explained below:

–
Insert the screw clamp fixing into the slot in the housing of the device
(see above figure).
–
Press the screw clamp fixing downwards, tilt it towards the housing
and check that it has firmly snapped into place.
–
Tighten the screw clamp fixing hand−tight with a screwdriver.
5. Check that the device is securely located in the mounting cutout and that
the front panel gasket is located correctly.
–
If necessary, realign the device/gasket.
–
If the gasket is not located correctly, protection class IP65 is not
achieved on the front of the device!
MA_ELx8xx DE/EN/FR/ES/IT 2.0
Panel PC EL 1800(s) / EL 1850(s)
‚
l
Installation
Mounting steps
ƒ
ELx7xx−011
4
33