Fitting The Accessories - Fagor MPA-600 Manual De Instrucciones

• Do not hang the styler from its cord.
• Do not wind the cord around the appliance.
• The electrical cord must not be replaced
by the user. If the cord is damaged, it must
only be replaced by a Technical Assistance
Service authorised by the manufacturer.
• Do not switch on the styler if
- the electrical cord is damaged
- the appliance is not in perfect working
order
- it has been dropped
• When the appliance is no longer useful,
unplug it from the mains and then cut its
electrical cord.
3. SAFETY
The hair styler is equipped with a an
overload protection system which
switches off the appliance if overheating
occurs (e.g. if the air inlet or outlet are
blocked). If the styler switches off during
use, turn the switch to "0" and wait for 5
minutes approx. Remove the cause of the
obstruction and switch it on again.

4. FITTING THE ACCESSORIES

Figs. 5 and 6
To fit the accessory onto the hair styler,
turn the mark so that it is opposite the
mark ( ); then fit the accessory onto
the appliance and turn it until the
opposite the mark (
= The accessory is correctly fitted onto
the appliance.
To remove the accessory, press the "Push"
button, turn the appliance until the
opposite the mark (
accessory it to release it.
The accessories must be released by pressing
the "Push" button.
FUNCTIONING
Plug in the styler with the accessory fitted to it.
Selector switch positions
0 = Off
1 = Medium temperature and speed
2 = High temperature and speed
= Cold air
mark is
).
mark is
) and pull on the
8
This allows for quick cooling after styling.
Mod. MPA-600 (Fig. 7)
Mod. MPA-1000 y MPA-1000i (Fig. 8)
In this position, the appliance blows out
cold air when the button is pressed and
held down.
Fixed position for cold air without
needing to hold the button down.
MPA-1000i: Ion generator (Fig. 9)
This function is used to give your hair a better
shine and to prevent static electricity.
To activate this function, push the switch
forward. The pilot light will come on.
5. CLEANING
Unplug the appliance before cleaning it.
Never submerge the appliance in water.
Remember to clean the air inlet grille regularly
with a brush to remove any dust and hair
which may have become trapped in it.
Clean the appliance with a damp cloth and
then dry it with a dry cloth.
Do not use abrasive cleaning products or
solvents. Remove the accessories before
cleaning them.
6. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working life, the
product must not be disposed
of as urban waste. It must be
taken to a special local authority
differentiated waste collection
centre or to a dealer providing
this service. Disposing of a
household appliance separately avoids possible
negative consequences for the environment
and health deriving from inappropriate disposal
and enables the constituent materials to be
recovered to obtain significant savings in energy
and resources. To remind you that you must
collaborate with a selective collection scheme,
the symbol shown appears on the product
warning you not to dispose of it in traditional
refuse containers. For further information,
contact your local authority or the shop where
you bought the product.