Fagor CC-70D Manual De Instrucciones página 11

interior 23/6/06
• Do not coil the cable tightly around the
appliance, as this can cause the cable
to peel and break.
• Do not operate the appliance if the cable
or the plug is damaged, if it does not
work correctly or it has fallen or has
been damaged in some way. Take the
appliance to an authorised technical
service when faced with any type of
technical problem to avoid risks.
• Do not use it outside.
• Do not use this heater close to a bath,
shower, swimming pool or close to any
other water container. If the heater gets
wet, unplug it from the power supply
before touching it, given that a wet
heater can give electric shocks, even
when they are switched off.
• The heater must not be placed right
under a plug socket.
• Do not run the cable under the carpet or
cover it with rugs, rails or similar. Fit the
cable far from walkway areas so it is not
tripped over or trodden on.
• Do not insert foreign bodies or allow
anything to enter the opening as it could
damage the heater or even cause an
electric shock or a fire.
• Do not use the heater in areas where
petrol, paint or flammable liquids are
used or stored, as it has parts which
project sparks.
• Do not use this heater with a
programmer, timer or other devices
which connect the heater automatically,
given that there is a fire risk if the heater
is covered or fitted incorrectly.
• In order to avoid an electric shock or
blowing the fuses, make sure that no
other appliance is using the same socket.
• Only use this heater as described in the
manual. Any other use not
recommended by the manufacturer
could cause a fire, electric shock or
other physical damage to people.
• Avoid the use of extension cables
because they can overheat the heater
and cause a fire.
• Always fit the appliance vertically on a
flat, stable floor. The appliance will not
operate if it is not resting appropriately
on the ground.
10:24 Página 9
IMPORTANT: Never cover the
appliance whilst it is working
as it could cause dangerous
overheating.
4. OPERATION
The appliance has a safety switch located
on the base which prevents the appliance
from working if it falls accidentally. For the
safety switch to operate, the appliance must
be resting on a firm and stable surface.
IMPORTANT: Do not try to block the
safety system in any way.
• Make sure that the heater is on a
horizontal and stable surface before
plugging it into the power supply. Once
plugged in, the LCD screen will show the
ambient temperature.
FUNCTIONS
Mode function
• Press the button to adjust the
operating mode: low, high or fan only.
• In order to change mode, press this
button again. The screen mode indicator
(c) will show which mode has been
selected. Every time this button is
pressed, the selected speed will vary
following the sequence in figure 3.
Temperature function
• Use this function to adjust the tempe-
rature.
• When this button is pressed the
selected temperature will appear, which
is 23 ºC by default.
• In order to select a temperature, use
buttons and
18 ºC to 35 ºC and the frost function
following the sequence in figure 4.
• A few seconds after selecting the
temperature, the screen will show the
ambient temperature again.
• The heater will be connected until the
desired temperature is reached and then
10
. You can select from