Using The Jump Starter - DieHard DH155 Manual Del Propietário

1. To charge, flip the AC connector
on the back of the unit down
and plug in an 18 AWG or larger
extension cord.
2. Plug the extension cord into a
120VAC electrical wall outlet.
3. While the unit is charging, the
RED LED will be on. Complete
charging may take up to 72
hours. When the RED LED turns
off, the unit is ready to use.
4. When the internal battery is
fully charged, the charger will
automatically go into maintain
mode and maintain the battery
at full charge without damaging
it. When in maintain mode,
the GREEN LED will pulse,
as long as there is an AC cord
connected to the charging port.
5. Charge the unit as soon as
possible after use.
4.3 CHARGING THE INTERNAL
BATTERY WHILE DRIVING
You may also charge the internal
battery while driving, using a male-
to-male charger cable (part number
94500109 – sold separately).
IMPORTANT: WHEN USING A
12V PORT CHARGING CABLE,
DO NOT CHARGE INTERNAL

5. USING THE JUMP STARTER

5.1 JUMP STARTING A VEHICLE
IMPORTANT: Using the Engine
Start feature without a battery
installed in the vehicle will damage
the vehicle's electrical system.
1. Turn the ignition OFF.
2. Lay the DC cables away from
any fan blades, belts, pulleys
and other moving parts.
3. For a negative-ground vehicle
(as in most vehicles), connect
the unit's POSITIVE (RED)
clamp to the POSITIVE (POS,
P, +) battery post. Next, connect
the NEGATIVE (BLACK) clamp
to the vehicle chassis or engine
block, away from the battery.
BATTERY FOR MORE THAN
30 MINUTES OR LEAVE THE
BATTERY UNATTENDED. IT
COULD EXPLODE, CAUSING
PROPERTY DAMAGE OR
PERSONAL INJURY.
1. Make sure the car is running.
2. Insert one end of the accessory
cable into the 12V DC power
outlet.
3. Insert the other end of the
accessory cable into the
vehicle's accessory outlet
(lighter socket).
NOTE: The RED LED does not
operate during this method of
charging. Using this method to
charge the battery overrides the
maintain mode and the battery can
be overcharged.
4. Monitor the progress of the
charge by pressing the Battery
Status button on the front of
the unit. When the battery is
fully charged, disconnect the
accessory cable from the unit,
then from the lighter socket of
the vehicle.
NOTE: Completely disconnect the
charger cable when the engine is
not running.
4. For a positive-ground
vehicle, connect the unit's
NEGATIVE (BLACK) clamp
to the NEGATIVE (NEG, N, -)
battery post. Next, connect the
POSITIVE (RED) clamp to the
vehicle chassis or engine block
away from the battery.
5. Crank the engine for no more
than 8 seconds. If the engine
does not start, wait 2 minutes
before cranking again.
6. After the engine starts, remove
the unit from the battery.
7. Charge the unit.
• 5 •