Technical Specifications; Operating Instructions - Dini Argeo MCWL Serie Manual Usuario

LOAD CELL
MAX. OVERLOAD
SAFETY FACTOR
POWER SUPPLY
REMOTE CONTROL
DIVISIONS DISPLAYED
DISPLAY
STATUS INDICATORS
KEYBOARD
AUTO POWER OFF
OPERATING TEMPERATURE From – 10 to +40° C
CASE
1) Suspend the instrument from the crane it will be used on and press push-button ON/OFF for a few
seconds: all segments on the display will light for a few seconds as the crane scale conducts a lamp and
other self-tests.
2) After the self-tests, press button for a few seconds marked ZERO/TARE. Especially important if the
display shows a non-zero value without a load on the scale.
3) If any accessories have been applied to the crane scale (connection rings, chains, hooks etc.) it is
necessary to press the ZERO/TARE key (pressed for an instant) or by using the remote control' s TARE
button.
Note: The ZERO/TARE key can be used with any weight applied in the range of its capacity.
4) When the display indicates " 0 ", the instrument is ready for use.
5) To switch off the instrument press the ON-OFF button FOR A FEW SECONDS.
Do not install MCW in environments with explosion risk
The crane scale must be used ONLY for TENSION measurements.
Movable loads which can cause torque stresses must behanged with
DO NOT STAND UNDER THE SUSPENDED LOADS

TECHNICAL SPECIFICATIONS

"S" beam. Strain gauge based with high accuracy and repeatability.
200% of full-scale value.
K=5 (500% of full-scale capacity).
9 V alkaline internal battery easy to replace. About 35-hour operating time.
fitted; it provides a maximum range of 8 m, configurable to operate tare
function only or as 4 keys remote keyboard.
3000 + 3000 + 3000 e
LCD, character height 25 millimeters
3 indications on the LCD display.
Water resistant key polycarbonate membrane with tactile feedback.
Adjustable from 1 to 30 minutes of no use, disinsertable.
Oven fired, painted IP54
BASIC OPERATING INSTRUCTIONS
!! WARNING !!
flexible or turnable constraints.
3