Battery Substitution; Remote Control - Dini Argeo MCWL Serie Manual Usuario

AUTO POWER OFF
FUNCTION OF AUTOMATIC TURN-OFF
This function allows to save energy in case of not using it temporarily; the automatic turn-off starts functioning
when the load stability is detected for the time programmed (see USER SETUP).
The values vary among:
00 DISABLED
01 1 minute
02 2 minutes
...
30 30 minutes

BATTERY SUBSTITUTION

An alkaline 9V battery is supplied together with the crane scale. In case it becomes necessary to substitute the
battery, pull out the battery holding drawer in the rear panel of the MCWL and proceed with the substitution.

REMOTE CONTROL

NOTE: The PROLONGED PRESSURE function of the keys is not repeatable on the remote control.
With the remote control it is possible to remote the functions of the main keys (ON/OFF, ZERO/TARE, F1, F2). The
function of the 4 keys of the remote control is defined in the irMd paramter (see USER SET-UP): it is possible to
carry out the TARE function with all the keys (ir 1), or repeat all the function keys of the indicator (ir 4).
NOTE: The function of the keys with PROLONGED function are not repeatable on the remote control
REMOTE CONTROL IN 4-KEY CONFIGURATION (ir 4)
KEY
1 KEY _Zeros (modifying the calibration of zero)
_exits the manual tare function zeroing the value in storage
2 KEY _Automatic tare
_if pressed for three seconds it allows to enter a manual tare value
_confirms the entered tare value
3 KEY _increases the blinking digit when entering the manual tare value.
_totalizes if the tot mode is selected.
4 KEY _Selects the PEAK/HOLD function (if the HoLd and PEAk modes are selected)
_Displays the TOTALIZED weight (if the tot mode is selected)
_Serves to select the digit following the blinking one (from left to right)
FUNCTION
7