3
- Press the child restraint down firmly and pull the vehicle shoulder belt to
fasten the child restraint securely. (15)
Ensure to close the lock-off after you are done checking the child restraint
is securely fastened. (15)-1
Keep your fingers off when closing the lock-off clips to avoid injury.
The child restraint can not be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the child restraint securely.
Double check that the child restraint is securely installed and does not
move on the vehicle seat.
Correctly assembled vehicle belt is shown as (16)
Ensure that the vehicle waist belt passes through the vehicle waist belt
slot. (16)-1
Ensure that the vehicle shoulder belt passes through the rear-facing vehicle
belt slot. (16)-2
The vehicle buckle tongue is engaged with the buckle correctly, as (16)-3.
Securing your Child in the Child Restraint Use Infant Insert
Detach the snaps on
the head support to
remove the head
portion of the insert.
We recommend using the full
infant insert while the baby
is 0-9 months or until they
outgrow the insert. The infant
insert increases side impact
protection.
11
TRES instructions
Remove the head support
portion of the infant
insert when the child's
head no longer fits
comfortably.
Remove the body
portion of the infant
insert when the infant's
shoulders no longer fit
comfortably.
Remove the infant insert
1
cushion by detaching the
snaps to allow more space
when the infant does not
fit comfortably. The
cushion can be used
2
separately without being
attached to the insert to
bolster the infant's back
for more comfort.
1
- While pressing the harness adjustment button, pull completely the two
shoulder harnesses of the child restraint. (17)
2
- Press the button to disengage the buckle. (18)
3
- Fix the buckles on the both sides of the child restraint to make placing the
rear facing more convenient. (19)
4
- Engage the buckle. (20)
5
- Pull the adjustment webbing toward you to adjust it to the proper length
and make sure your child is snugly secured. (21)
After the child is seated, recheck whether the shoulder harnesses are at
the proper height.
Always keep child secured in harness and properly tightened by removing
any slack.
Forward Facing Mode
(for Child 15–36kg /3–12 years old)
Installation for Forward Facing Mode
When using in the forward facing mode, please remove the infant insert,
and place the shoulder harness straps, buckle and buckle tongues in the
harness hideaway storage compartments.
Please adjust the shoulder harnesses to proper length before storing the
shoulder straps and buckle in their storage compartments.
Please adjust the child restraint to the desired recline position. (4 positions
for forward facing mode). Align the top reclining indicator with one of the
bottom red numbers.
While using and adjusting the vehicle seat belt, check that there are no
twists in the vehicle seat belt that could cause your child incorrectly
fastened.
1
- Press the button to disengage the buckle as (18).
2
- Remove Crotch Strap as (37) and then the infant insert.
When installing the child restraint in the forward facing mode, do not use
the infant insert.
3
- Detach the snaps. (22)-1
12
TRES instructions