Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ENGLISH

HOW TO USE

Several Receivers can be used at the same time.
It is even possible to create different DMX universes by using several Transmitters together.
To set up the system, you first need to assign each receiver to the universe (transmitter) it should work with.
VERY IMPORTANT THINGS TO KNOW BEFORE USE
Before you start using these wireless DMX units, you should know about the following some basic
information. It will save you a lot of time and frustration:
A DMX-controller (switched on) should be connected to the transmitter while synchronizing
receivers.
Check information on the setup button (2) and status led (3) in the previous chapter.
A receiver can only connect to a transmitter while it is completely disconnected: status led (3) is off.
ADDING ONE OR SEVERAL RECEIVERS TO A TRANSMITTER
To add your receivers to a specific transmitter:
a) Make sure that the receivers to be connected are not linked to another transmitter: the status led (3)
on these receivers should be off.
b) Press the setup button (2) of the transmitter shortly; the status led (3) on both the transmitter and
receivers starts blinking.
c) Wait until blinking stops: the receivers are now linked to the transmitter.
d) Check if the connection was made properly: press the setup button (2) on the transmitter again, the
status led (3) on all linked receivers start blinking. Receivers linked to another transmitter will not
blink.
DISCONNECTING RECEIVERS FROM A DMX UNIVERSE
To disconnect all the receivers from a DMX universe / transmitter:
Press the setup button (2) of the transmitter for about 5 seconds until the status LED (3) starts
blinking.
ALL receivers that were connected to this transmitter (DMX universe) will all be disconnected. The
status LED of the receivers will also turn black.
To disconnect an individual receiver from a DMX universe / transmitter:
Press the setup button (2) of the receiver until the status LED (3) is switched off.
This receiver is now disconnected from the transmitter (DMX universe).
BRITEQ
®
5/30
OPERATION MANUAL
WIRELESS DMX SYSTEM

Publicidad

Tabla de contenido
loading

Productos relacionados para Briteq WR-DMXG4

Este manual también es adecuado para:

Wt-dmxg4

Tabla de contenido