Setup Wizard - Harman Kardon BDS 270 Guia De Inicio Rapido

BDS 270/BDS 570

Setup Wizard

When you turn your BDS receiver on for the first time, the on-screen menu will display
the Setup Wizard.
Setup Wizard
Welcome to the Harman Kardon BDS Setup
Wizard.
Some simple information is needed to ensure
you get the best experience from your product.
You can adjust these settings later in addition
top making changes to more advanced settings
by selecting 'Settings' from the Home Menu.
Before you can use your BDS system you need to set the language and make a few basic
settings so that the BDS receiver's video output will work properly with your TV.
Press the OK button, and the Wizard's language screen will appear.
Setup Wizard
Please select which language you would like
the BDS menus to appear in.
Previous
After setting the language you want the on-screen menus to appear in, press the OK
button, and the Wizard's TV resolution screen will appear.
Setup Wizard
Please select the highest resolution that your TV
supports. If you are unsure, select 'Auto'.
Upon making a selection the screen will be
changed to the chosen resolution. You will be
presented with the option to continue with the new
resolution or 'Cancel' to return to the previous
resolution. If the screen remains blank, please wait
15 seconds without pressing anything and the
system will automatically return to the previous
resolution.
Previous
After selecting your TV's highest resolution, press the OK button, and the Wizard's aspect-
ratio screen will appear. NOTE: If you are unsure of your display's highest resolution,
select "Auto" and the BDS receiver will select the optimal resolution for you.
Setup Wizard
Please select the best aspect ratio that fits your TV.
Please see the owners manual for additional
explanation.
Previous
After selecting the aspect ratio that best fits your TV, press the OK button to save your
settings and then press it again to exit the Setup Wizard.
8
Page: 1/5
Next
OK
Page: 2/5
English
Español
Français
Deutsch
Italiano
Next
OK
Page: 3/5
Auto
480p/576p
720p
1080i
1080p
Next
OK
Page: 4/5
16:9 Full
16:9 Normal
4:3 Pan & Scan
4:3 Letterbox
Next
OK
Setup Wizard and Configure the Receiver
Configure the Receiver for Your Speakers
Before you use your BDS receiver you need to configure it to work with your particular
speaker system. The BDS receiver's EZSet/EQ
microphone to perform this important step automatically. Before beginning, be sure you
have correctly connected your speakers to the BDS receiver. IMPORTANT: Press the
remote's "Disc" input button before performing the EZ Set/EQ procedure. The EZ
Set/EQ procedure is only available when the Disc input is selected.
1. Plug the supplied EzSet/EQ microphone into the BDS receiver's Headphone connector.
EzSet/EQ Microphone
(supplied)
2. Place the microphone at ear height in your main listening position.
3. Press the remote control's Home button. The receiver's Home Menu screen will appear
on the TV.
Home Menu
Blu-ray Disc
FM Radio
HDMI input
Component input
Playlist
Settings
1 / 5
4. Use the Cursor and OK buttons to highlight and select Settings. The General Settings
menu will appear.
General Settings
System
Language
Playback
Parental Control
Network
Select to adjust general settings
5. Use the right Cursor button to select Audio Settings, then use the down Cursor button
to select Speaker Settings. The Speaker Settings screen will appear.
Audio Settings
Tone Controls
Audio Output
Speaker Settings
Select to adjust speaker settings
system uses the supplied EzSet/EQ
™
Headphone
Connector
Type: Settings
Exit Option
HOME OPTIONS
EzSet/EQ 2.0
Manual Configuration 2.0