Risco VUpoint RVCM32W Guia De Instalacion página 12

Powering-up the IP Camera
1. Connect power to the Power port on the IP camera.
2. Connect power to an electrical outlet. When the IP camera boots up, the
GREEN power indicator light flashes.
Connecting the IP Camera to the Network
The IP camera supports several network connection options including LAN and
Wireless.
Connecting to a LAN Network
Connecting the IP camera to a network using the LAN (Local Area Network)
enables easy connection and setup with compatible APs (Access Points), e.g.
gateway or router.
1. Connect the incoming network cable to the Network port on the IP camera.
2. The GREEN network indicator lights to indicate that your IP camera is now
connected to the network. Continue as explained in Defining IP Camera
Settings.
Connecting to a Wireless Network using WPS
Connecting the IP camera to a wireless network using WPS (Wi-Fi Protected
Setup) requires that the router supports WPS functionality.
NOTE – Some routers have a virtual button on their management software.
(Refer to the router's documentation for details about using its WPS functions).
1. Once the power cord is connected, wait for slow flashing GREEN network
indicator.
2. Momentarily press the WPS button on the IP camera and hold down the
WPS button on the router for 2 seconds. The GREEN network indicator light
indicates that your IP camera is now connected to the network. Continue as
explained in Defining IP Camera Settings.
10