Folding And Disassembling; Removing The Wheels - Maxi-Cosi Mura Modo De Empleo/Garantia

Locking the swivel wheels
1. Slide the swivel locks on the front wheels down and turn
the front wheels to the rear position until you hear a
'click' (Fig. 19).
2. To release the lock lift up the swivel lock.
Maxi-Cosi Mura sun canopy
Attaching the sun canopy
1. Attach the clips on to the tubes on the sides of the seat
backrest. Make sure the holes in the clips snap over the
buttons. Place the top of the clip over the tube first and
then push the bottom until it 'clicks' into place (Fig. 20).
Using the sun canopy
2. Fold open or close the sun canopy using the lever (1)
(Fig. 21). To release the sun canopy, pull the levers on
both sides slightly outwards. Adjust the sun canopy into
the desired position and 'click' it into place (Fig. 22/23).
3. When using the backrest in the flat or reclining position,
the extra sun flap under the sun canopy can also be
used. Pull the flap up and outwards (Fig. 24).
Basket
1. The basket can be used for shopping up to a maximum
of 5 kg (Fig. 25).
2. You can attach and remove the basket using the
press studs, hooks and elastics (on the bottom of the
Maxi-Cosi Mura).
- Note: do not exceed the maximum permitted weight of
5 kg!

4.2 Folding and disassembling

Folding
1. If you want to fold the Maxi-Cosi Mura with the seat still
attached, this is only possible when the seat is attached
in the forward-facing position and the back rest is in the
extreme forward position (Fig. 26).
- We recommend that the seat is always removed before
starting to fold the pushchair.
2. Fold back the sun canopy parallel to the handlebar
(Fig. 21).
3. Turn the fold safety lock on the right side downwards and
then simultaneously pull the folding-up release buttons on
both sides upwards (Fig. 27).
4. Tilt the handlebar forwards and then down until it 'clicks'
into the transport lock (Fig. 28).
10
EXI0277_Mura_4_I_BW.indd 10 EXI0277_Mura_4_I_BW.indd 10
If you want to fold the frame even smaller:
5. Remove the seat before starting folding.
6. Turn the front wheels forward.
7. Press the release button (Fig. 29).
8. The frame folds even smaller.
9. Remove the wheels if necessary.

Removing the wheels

1. Rear wheels: press on the centre of the hubcap and at
the same time pull the rear wheels out of the frame
(Fig. 30).
2. Front wheels: press in the release buttons on both sides
and pull the front wheels out of the front fork (Fig. 31).
21-07-09 12:08 21-07-09 12:08