Flamingo HOME MONITOR FA703IP Manual De Instrucciones página 20

4.2.2. iOS
• Download the App: "Plug2View" from the App Store and
install it.
• Start the App.
The "Login" screen of the App shows
the App, you can register an account and you can download a QR
code scanner.
Registering an account
• Click on "Register", the screen "Register Account" shows
• Enter your username at "Username".
• Enter your password at "Password".
• Enter your password once again at "Please enter again".
• Enter your email address at "Email".
• Click on "Done". When the registration is successful, a message
"Register success" is displayed.
• Click on "OK" and then "Login" to return to the "Login" screen.
Scanning QR Code
• Click on "Scan QR Code" and then scan a QR code. This must
entirely fit within the white square.
• Press "Cancel" to go back again without scanning.
Login to the App
• Input the camera code at "Username" and the camera
20
. Here you can log in to
E
.
F
password at "Password". You can find both codes on the back
of the camera.
• If you want the App to remember your password, move the
box behind "Remember Password" to the right so that "I" is
visible.
• Click on the "Login" button. The screen "Remote Device" shows
. Here you can see if the camera is connected (ONLINE) or if
G
it is not connected (OFFLINE).
Your camera has been added to your phone and will appear on
the start screen of your App.
4.2.3. General
• For instructions on placing your camera go to section 4.7.
• For instructions on using your camera with the App go to
chapter 5.
4.3. Install your camera on your PC
• Insert the included CD-ROM into your computer.
• Launch "SYSM Monitor.exe" from the CD-ROM.
• To run through the installation, click on "Next" three times.
• Complete the installation by clicking on "Restart computer".
The IP camera tool is now installed on your computer. You will find
the shortcut on your desktop.