Playing Radio Stations; Removing The Ci Module; Calling The Ci Module Menu; Digital Audio Output - Loewe DVB-T Instrucciones De Manejo

Daily handling

Playing radio stations

Change to radio mode with RADIO in order to play radio stations
(Exception: During active timer recording).
Call up the station table by pressing the OK button. You can then call, sort
and rename radio stations etc. exactly the same as for TV stations.
Press RADIO again to change back to TV mode.
Radio mode: 5 B5 AKTL
AUDIO IN
AVS
AV2
AV1
1 B5 AKTL
D
2 BAYERN 1
D
3 BR4 KLSK
D
4 SUNSHINE
D
5 ROCK ANT
D
6 ANTENNE
D
7 DLR
D
8 DLF
D
Switch over
OK
Select station
...
0 9
Screen off
You can play the radio stations for a few seconds from the selected entry
upwards using the green button "Play stations". Pressing the green
button again stops the play.
You can switch off the screen in order to save energy using the red button.
Pressing the red button again or OK
switches the screen on again.

Removing the CI module

1. Switch off your TV at the power switch.
2. Press in the eject button on the slide-in module, the module jumps out.
3. Pull the module out of the set.
12
DVB_T_S_GB_F_Esp
9 HR-INFO
D
10 MDR INFO
D
11 MDR FIGA
D
12 NDR KULT
D
13 SWR1
D
OK
14 SWR2
D
15 WDR3
D
16 WDR5
D
17 OESTER 1
D
18 MDR JUMP
D
19 JAZZ RAD
D
20 BLUSAT20
D
Scan sations
END
Previous channel
MENU
Change sorting
12

Calling the CI module menu

Here you can call information about the plugged Common-Interface
module and Smartcard. To do this, call the TV menu, select the "Settings"
line and then the item "CI-Module I/II – xxx".
The content of this menu depends on the respective CI module provider.
Note:
This menu is only available with digital programs.
New CI module plugged
After plugging a new CI module and switching on the TV set, the
following dialog box appears:
Autom. channel search
Your TV set has detected a new CI module. This requires a
program search for all new receivable programs.
Continue with OK
After pressing the OK button, the wizard for the automatic station search
is started. Please check the suggested search parameters there.
Continue with the section "Automatic station search" on page 8.

Digital audio output

You can also use the digital audio signals which your TV receives for
playing or recording the sound by an external audio system. The digital
sound output „DIGITAL (SPDIF) OUT" (see fig. page 4) gives the sound
accompanying the television/radio programme.
Sound selection
If you are receiving a digital TV/radio programme with several sound
formats, you can call up the menu „Language/Sound selection" by
pressing the END button. Press the green button after this.
If you have connected an external Dolby Digital decoder or the Loewe
AURO Preceiver and have entered this in the connection wizard, you
should now select „Dolby Digital".
Note: The sound outputs of the TV set and speakers do not emit any sound
signals in this operating mode (Exception: the TV speakers are used as
active centre channel).
Only Stereo/PCM is reproduced with the setting "Sound via TV". This must
be considered when selecting the sound.
18.11.2004, 13:51 Uhr
END