Safety Information - Twin-Star International KC7005-T401-42 Manual De Instrucciones

SAFETY INFORMATION

WARNING
• Before assembly, carefully use scissors or utility knife to cut and unwrap all parts.
Make sure you do not discard the hardware.
CAUTION
• Use care in assembling your new kitchen cart. Take your time and use the
hardware provided and a quality Phillips head screwdriver. Never overtighten bolts.
• Do not sit on any part of the kitchen cart.
• All panels are labeled left and right as viewed from the front of unit.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Insert wood dowels (CC) into the holes in the Base
(A) and insert Nut (NN) into the bottom of panels
(E,F,Q,L). Push the Left / Right side panels (E,F),
Left/Right center panels (L, Q) snug to the Base as
shown in diagram. Screw Hex screw (AA) into Flat
Washer (BB) with Allen Key (DD) through the base
to connect them, make sure them screw in the nuts.
Hardware Used
AA
Hex screw
BB
Flat Washer
CC Wood Dowel ø8
Allen Key
DD
Nut
NN
Fig. 1
L
E
x 8
x 8
x 8
x 1
x 8
4
NN
F
BB
Q
A
CC
AA
DD