Twin-Star International KC7005-T401-42 Manual De Instrucciones página 7

5. Choose desired height of Interior wood shelves (H)
and place the Shelf Pins (HH) into same height shelf
holes inside side panels. Insert Wood Shelves (H),
allow Wood Shelves (H) to rest on the Shelf Pin
(HH), use Screws (LL) to fi x the shelves.
Hardware Used
HH
Shelf Pin
LL Screw
6. Locate Right Doors (C) and Left Doors (B),
attach the hinge another part to the side panels with
screws (Diagram 1). Slide door hinge keyhole into
panel hinge bracket. Use Phillips Head Screwdriver
to tighten screws. (Diagram 2)
TO ADJUST HINGES
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 2a)
To adjust door right or left loosen/tighten screw.
(As Shown In Diagram 2b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 2c)
Attach the Knob (FF) to the Left Doors (B) and Right
Doors (C) and upper drawers, use the bolts attached
through the pre-drilled holes in the doors. Then use
a Phillips Head Screwdriver to tighten the bolts.
Hardware Used
FF
Knob (with bolt)
LL Screw
7. Install the sliding frames with the panels (R,V,U,S),
insert the wood dowels (PP) on the holes and
connect the four panels together with screws (QQ).
Hardware Used
QQ
Screw
PP
Wood Dowel ø6
Fig. 5
x 8
x 8
Fig. 6
C
x 8
x 32
Fig. 7
x 14
QQ
x 2
QQ
6
H
HH
LL
1
C
B
PP
R
U
S
2
FF
V