Service - Dustcontrol DC AirCube 500 Manual Original

Service DC AirCube 500
While performing cleaning or maintenance on the
machine, the unit should be off and disconnected
from the power supply.
When the suction is reduced, due to the fi lters be- When the suction is reduced, due to the fi lters be-
coming clogged. The pre-fi lter should be changed. coming clogged. The pre-fi lter should be changed.
Turn the "soft" surface out and the "hard" surface Turn the "soft" surface out and the "hard" surface
towards the HEPA-fi lter. towards the HEPA-fi lter.
If the suction still is weak, the HEPA fi lter should If the suction still is weak, the HEPA fi lter should
be changed too. With heavy dust loads the life of be changed too.
the fi lters are shorter. Use only original spare part
fi lter 4080. Use suitable breathing protection and
do the operation in a closed room. The used fi lter
should be sealed in a plastic bag and disposed of
according to approved methods.
Montage:
Montage of prefi lter:
2016-04-04
Check regularly that the electrical cable is not da-
maged in any way. With replacement of the cable
and contact, use only water proof replacements.
The DC AirCube 500 should be performance
tested and checked at least once per year or more
frequently if subject to intensive use.
Because this machine is used with dangerous sub-
stances maintenance is vital, worn parts should be
replaced.
Never compromise the function of the DC AirCube
500, use only original spare parts.
The fan is maintenance free.
•
When light is on, it's time for service!
Change of prefi lter:
Change of HEPA fi lter:
DC AirCube - 16
Part No 94178-C