Operation - Dustcontrol DC AirCube 500 Manual Original

Description DC AirCube 500
Th e DC AirCube 500 aircleaner is intended for cleaning
the air in a work area and is intended for use as a compli-
ment to spot extraction. Air is passed through a combina-
tion prefi lter and a microfi lter. Th e microfi lter is a HEPA
13 fi lter separates particles to 99.95%. Th e pre- fi lter
separates the majority of the course particles and thereby
prolonging the life of the microfi lter.
When a loss of suction capacity is experienced the pre-
fi lter should be changed. If the suction capacity does not
increase after the pre-fi lter change then the Hepa fi lter
should also be changed.
NOTE: When using a long tube or covering the outlet,
the warning light (fi lter light) can be lit.
Check when changing the fi lter that the outlet is free
(warning light).

Operation

Connect the machine to a suitable power source accor-
ding to the specifi cation of the machine. When using an
extension cable with the machine, ensure that the con-
nection is water tight and the extension cable is suitably
rated.
Th e fan has two speed settings which allow for economi-
cal running, for example during the night.
Th e DC AirCube 500 can also be used to discharge air
from work places which must be kept under negative
pressure. A 125 mm hose can be attached to the fan out-
let where necessary.
Optinal power outlet 240 V 1200 W.
Th e DC AirCube aircleaner has two speed settings which
allows for economical running, for example during the
night.
DC AirCube - 15 Part No 94178