Electrical Connection; Startup; Checking The Delivery Contents; Before Using For The First Time - Beem Multi-FiXX 1000 Manual De Instrucciones

EN

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on
the electrical connection must be be ob-
served:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. This
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains cable is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the mains cable to prevent risk
of tripping.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle
Multi-FiXX 1000

Startup

Unpacking
Remove the appliance, all accessory
‹
parts and the user manual from the
box.
Remove all packaging materials and
‹
protective foils from the product and
the accessories before using it for the
first time.
NOTE
► Do not remove the rating plate or
any warning signs on the appliance.
► Keep the original packaging during
the guarantee period in order to pack
the appliance properly in the event
of a guarantee or warranty claim.
Transport damage will invalidate the
warranty or guarantee.

Checking the delivery contents

Check for visible signs of damage or
‹
missing items.
Report incomplete or damaged con-
‹
tents to your supplier immediately.

Before using for the first time

Clean the appliance and the acces-
‹
sories as described in the section
Cleaning and care (page 43).
NOTE
► When using for the first time, it is
possible that production-related
additives such as grease could
cause slight odour or smoke. This is
completely normal. Ensure sufficient
ventilation.
29