Cleaning And Maintenance - Philips Mistral GC2225 Manual De Instrucciones

Ocultar thumbs Ver también para Mistral GC2225:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
8
Drip Stop (types GC2225, GC2220 only)
This iron is equipped with a drip stop function: the iron automatically
stops steaming when the temperature is too low to prevent water
from dripping out of the soleplate.When this happens you will hear a
click.
Automatic shut-off (type GC2225 only)
An electronic safety device will automatically switch the heating
element off if the iron has not been moved for a while.
C
To indicate that the heating element has been switched off, the
red auto-off pilot light will start blinking.
To heat up the iron again:
1
Pick up the iron or move it slightly.
2
The red auto-off pilot light will go out.The amber temperature
pilot light will go on, depending on the soleplate temperature.
3
If the amber pilot light goes on after the iron has been moved,
wait for it to go out before you start ironing.
4
If the amber light does not go on after the iron has been
moved, the iron is ready for use.

Cleaning and maintenance

Calc-Clean
The Calc-Clean function removes scale and impurities.
Use the Calc-Clean function once every two weeks. If the water in
your area is very hard (i.e. when flakes come out of the soleplate
during ironing), the Calc-Clean function should be used more
frequently.
1
Set the steam control to position O.
2
Fill the water tank to the maximum level.
Do not pour vinegar or other descaling agents into the water tank..
C
3
Set the temperature dial to MAX.
4
Put the plug in the wall socket.
5
Unplug the iron when the amber pilot light has gone out.

Publicidad

Tabla de contenido
loading

Tabla de contenido