Makita XGD01 Manual De Instrucciones página 10

Mounting the auger bit
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When installing the bit adapter to
the chuck, make sure that the bit adapter is fully
inserted.
CAUTION:
When attaching the auger bit to the
bit adapter, make sure that the auger pin is locked
and inspect the auger pin for any damages.
CAUTION:
When carrying the tool, remove
the auger bit from the tool.
Installing or removing the bit adapter
To mount the auger bit, install the bit adapter in
advance.
To install the bit adapter, place the bit adapter in the
chuck as far as it will go. Tighten the chuck by rotating
the sleeve by hand.
Place the chuck key in the chuck hole and tighten clock-
wise. Be sure to tighten all three chuck holes evenly.
To remove the bit adapter, turn the chuck key counter-
clockwise in just one hole, then loosen the chuck by
hand.
2
3
► 1 . Chuck key 2. Chuck 3. Sleeve
After use, return the chuck key to the storage cavity on
the tool as illustrated.
Mounting the auger bit on the bit adapter
NOTE: The shape and mechanism of the auger bit
and the auger pin may vary depending on your auger
bit.
Align the hole on the bit adapter with the hole on the
auger bit.
Put the auger bit onto the bit adapter.
► 1 . Auger bit 2. Bit adapter
Fix the auger bit with the auger pin and the safety lock.
1
► 1 . Auger pin 2. Safety lock
OPERATION
CAUTION:
generates high torque. It is important that the tool
is securely held and properly braced.
CAUTION:
is no foreign matter (sand, dirt, etc.) stuck in the
openings or moving parts.
10 ENGLISH
2
1
1
2
This is a powerful tool whitch
Before operating, check that there